REL-IR-BL/L-115AC/2X21 - Single relay Phoenix Contact

Mã sản phẩm: 1109556

Danh mục: PHOENIX CONTACT, Switch, Measure and Monitor Phoenix Contact,

Plug-in industrial relay in basic design with power contacts, 2 changeover contacts, test button, status LED, mechanical switch position indicator, input voltage: 115 V AC

Liên hệ mua hàng

Hãng sản xuất: PHOENIX CONTACT

Chất lượng: Mới 100%

Bảo hành: Chính hãng

Chứng từ: CO/CQ, hóa đơn VAT

Liên hệ(SĐT/Zalo): 0933612627

Mô tả

General	Do not connect adjacent channels to SELV/ PELV and voltages dangerous to the touch.
General	The outputs are not suitable for switching different outer conductors.
General	Do not use to separate SELV / PELV circuits from other circuits, because safe isolation is not guaranteed.

Product type	Single relay
Operating mode	100% operating factor
Mechanical service life	2x 10⁷ cycles
Insulation characteristics
Insulation	Basic insulation
Insulation characteristics: Air clearances and creepage distances between coil and contact side
Insulation	Basic insulation
Overvoltage category	III
Pollution degree	2

Service life electrical	see diagram
Maximum power dissipation for nominal condition	1 W
Test voltage (Winding/contact)	2.5 kV_rms (50 Hz, 1 min., winding/contact)
Test voltage (Changeover contact/changeover contact)	2.5 kV_rms (50 Hz, 1 min., changeover contact/changeover contact)
Air clearances and creepage distances between coil and contact side
Rated insulation voltage	250 V AC
Rated surge voltage	5 kV

Coil side
Nominal input voltage U_N	115 V AC
Input voltage range	92 V AC ... 189.8 V AC (20 °C)
Mains frequency	50/60 Hz
Typical input current at U_N	9.2 mA
Typical response time	5 ms ... 15 ms
Typical release time range	5 ms ... 20 ms
Coil voltage	115 V AC
Status display	Yellow LED
Coil resistance	4.8 kΩ ±12 %

Switching
Contact type	2 changeover contacts
Type of switch contact	Single contact
Drive and function	monostable
Drive (polarity)	bipolar
Contact material	AgNi
Maximum switching voltage	250 V AC/DC
Minimum switching voltage	12 V (10 mA)
Limiting continuous current	12 A
Maximum inrush current	24 A (20 ms, N/O contacts)
Min. switching current	10 mA (12 V)
Interrupting rating (ohmic load) max.	288 W (24 V DC)
		130 W (48 V DC)
		90 W (60 V DC)
		66 W (110 V DC)
		88 W (220 V DC)
		3000 VA (250 V AC)
Switching capacity min.	120 mW

Connection method

Plug-in connection

Width	22.5 mm
Height	28 mm
Depth	35.5 mm

Ambient conditions
Degree of protection	RT II
Degree of protection (Installation location)	≥ IP54 (Installation location)
Ambient temperature (operation)	-40 °C ... 70 °C
Ambient temperature (storage/transport)	-40 °C ... 70 °C
Altitude	≤ 2000 m