DEK-OE-125DC/ 48DC/100/T - Solid-state relay terminal block Phoenix Contact

Mã sản phẩm: 2940294

Danh mục: PHOENIX CONTACT, Switch, Measure and Monitor Phoenix Contact,

Input solid-state relay terminal block, input: 125 V DC, output: 3 - 48 V DC/100 mA, with isolating plug in output, terminal block width: 6.2 mm

Liên hệ mua hàng

Hãng sản xuất: PHOENIX CONTACT

Chất lượng: Mới 100%

Bảo hành: Chính hãng

Chứng từ: CO/CQ, hóa đơn VAT

Liên hệ(SĐT/Zalo): 0933612627

Mô tả

General

The housing is open on one side. The appropriate cover is D-DEK 1,5 GN (2716949).

General

Use of EB 80-DIK... bridges in the DEK terminal blocks: Absorption of humidity from the ambient air as well as an unfavorable tolerance between a larger number of DEK terminal blocks and the EB 80-DIK... bridge may cause (minor) expansion of the DEK housing. When the EB 80-DIK... bridges are used, therefore, it is recommended that these be disconnected after about 10 to 12 DEK terminal blocks and a wire bridge to the next DEK terminal block be inserted in their place.

Product type	Solid-state relay module
Product family	DEK
Application	Input function
Operating mode	100% operating factor
Insulation characteristics
Overvoltage category	III
Pollution degree	2

Test voltage (Input/output)

2.5 kV AC (Input/output)

Nominal input voltage U_N	125 V DC
Input voltage range in reference to U_N	0.9 ... 1.1
Input voltage range	112.5 V DC ... 137.5 V DC
Switching threshold "0" signal, voltage	≤ 50 V
Switching threshold "1" signal voltage	≥ 100 V
Typical input current at U_N	3 mA
Typical response time	40 µs (delay)
Typical turn-off time	40 µs (delay)
Status display	Yellow LED
Protective circuit	Reverse polarity protection; Bridge rectifier
Transmission frequency	30 Hz

Contact type	1 N/O contact
Design of digital output	electronic
Output voltage range	3 V DC ... 48 V DC
Limiting continuous current	100 mA
Voltage drop at max. limiting continuous current	≤ 0.9 V
Output circuit	2-conductor, floating
Protective circuit	Reverse polarity protection; Polarity protection diode
Protective circuit		Surge protection

Connection method	Screw connection
Stripping length	8 mm
Screw thread	M3
Conductor cross section rigid	0.2 mm² ... 2.5 mm²
Conductor cross section flexible	0.2 mm² ... 2.5 mm²
Conductor cross section AWG	24 ... 14
Tightening torque	0.5 Nm