SACC-E-M12FS-5PL-M20 - Panel feed-through Phoenix Contact

Mã sản phẩm: 1139805

Danh mục: PHOENIX CONTACT, Kết nối (Connect) Phoenix Contact 3,

Panel feed-through, Universal, 5-position, unshielded, Socket straight M12, A, Front mounting, M20 x 1,5, Push-lock connection, knurl material: Nickel-plated brass, Flat nut included

Liên hệ mua hàng

Hãng sản xuất: PHOENIX CONTACT

Chất lượng: Mới 100%

Bảo hành: Chính hãng

Chứng từ: CO/CQ, hóa đơn VAT

Liên hệ(SĐT/Zalo): 0933612627

Mô tả

General	NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.
General	The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration.

Mounting type	Front mounting M20 x 1,5
Assembly instructions	The wires can be connected both with ferrules and without ferrules
Connection method	Push-lock connection

Product type	Circular connectors (device side)
Number of positions	5
Sensor type	Universal
No. of cable outlets	1
Shielded	no
Coding	A
Cable outlet	straight
Insulation characteristics
Overvoltage category	II
Degree of pollution	3

Dimensional drawing
Length	19.2 mm
Housing
Diameter housing	29 mm

Material	PA 6
Flammability rating according to UL 94	V0
Seal material	NBR
Contact material	CuSn
Contact surface material	Ni/Au
Contact carrier material	PA 6.6
Material for screw connection	Nickel-plated brass

Rated surge voltage	1.5 kV
Contact resistance	≤ 5 mΩ
Insulation resistance	≥ 100 MΩ
Nominal voltage U_N	48 V AC
Nominal voltage U_N		60 V DC
Nominal current I_N	4 A (2 A when using 0.14 mm² conductors)

Conductor connection
Connection method	Push-lock connection
Conductor cross section flexible	0.14 mm² ... 0.75 mm²
Cross section AWG	26 ... 18
Tightening torque	0.4 Nm