FLKM-PA-D37/HW/AN/C300/TAIX/P - Front adapters Phoenix Contact

Mã sản phẩm: 1081062

Danh mục: PHOENIX CONTACT, Kết nối (Connect) Phoenix Contact,

VARIOFACE front adapter, for Honeywell C300, Series C I/O, maximum of 1 x 16 channels can be connected (37-position D-SUB connector). Specially designed to connect analog I/O cards and transition them to passive operating mode.

Liên hệ mua hàng

Hãng sản xuất: PHOENIX CONTACT

Chất lượng: Mới 100%

Bảo hành: Chính hãng

Chứng từ: CO/CQ, hóa đơn VAT

Liên hệ(SĐT/Zalo): 0933612627

Mô tả

Product type	Front adapter
Insulation characteristics
Insulation	Functional insulation
Insulation characteristics: Air clearances and creepage distances
Insulation	Functional insulation
Overvoltage category	II
Pollution degree	2

Operating voltage (AC)	≤ 25 V AC
Operating voltage (DC)	≤ 60 V DC
Nominal operating mode	100% operating factor
Current (Per path)	≤ 1 A
Current ()	≤ 4 A ()
Air clearances and creepage distances
Rated insulation voltage	63 V
Rated surge voltage	0.6 kV
Supported controller HONEYWELL Experion PKS C300/C-Series
Suitable I/O card	TAIX01 (non-redundant)
Suitable I/O card		TAIX11 (redundant)

Field level
Connection method	D-SUB pin strip
Number of connections	1
Number of positions	37
Supply
Connection method	Push-in spring connection
Stripping length	10 mm
Conductor cross section rigid	0.2 mm² ... 4 mm²
Conductor cross section flexible	0.2 mm² ... 2.5 mm²
Conductor cross section AWG	24 ... 12

Ambient conditions
Degree of protection	IP00
Degree of protection (Installation location)	≤ IP54 (Installation location)
Ambient temperature (operation)	-20 °C ... 70 °C
Ambient temperature (storage/transport)	-20 °C ... 70 °C
Altitude	≤ 2000 m

Air clearances and creepage distances
Standards/regulations	DIN EN 50178

Assembly instructions	in rows with zero spacing
Mounting position	any

General	No additional touch protection is required when using a SELV/PELV voltage (≤ 25 V AC or 60 V DC).
General	Against adjacent modules in the support rail direction at least one functional insulation on the output-side is complied with. If the application has higher requirements on the insulation (basic insulation or reinforced insulation), then these must be realized through suitable measures (e. g. partition plates).