FLKM-2KS50/BFI/SPT/CS/C-L - Passive module Phoenix Contact

Mã sản phẩm: 2321842

Danh mục: PHOENIX CONTACT, Kết nối (Connect) Phoenix Contact,

Termination board for Yokogawa ADV 151, ADV 161, ADV 551 and ADV 561 I/O modules with a fuse for cable protection (5 x 20) and fuse failure display (LED) per channel. Redundant system connection.

Liên hệ mua hàng

Hãng sản xuất: PHOENIX CONTACT

Chất lượng: Mới 100%

Bảo hành: Chính hãng

Chứng từ: CO/CQ, hóa đơn VAT

Liên hệ(SĐT/Zalo): 0933612627

Mô tả

General	Voltage monitoring on the module does not work in combination with upstream HESILED fuse terminal blocks with integrated LED display.
General	Do not connect adjacent channels to SELV/ PELV and voltages dangerous to the touch.
General	No additional touch protection is required when using a SELV/PELV voltage (≤ 25 V AC or 60 V DC).
General	Against adjacent modules in the support rail direction at least one functional insulation on the output-side is complied with. If the application has higher requirements on the insulation (basic insulation or reinforced insulation), then these must be realized through suitable measures (e. g. partition plates).

Product type	Interface module
No. of channels	32
Operating mode	100% operating factor
Insulation characteristics
Insulation	Functional insulation
Insulation characteristics
Insulation	Functional insulation
Overvoltage category	II
Pollution degree	2

No. of channels	32
Nominal voltage U_N	24 V DC
Nominal voltage U_N		19.2 V DC ... 26.4 V DC
Max. current carrying capacity per branch	100 mA (observe derating)
Max. total current of all branches	4 A (observe derating)
Rated insulation voltage	50 V DC
Rated surge voltage	0.5 kV
Supported controller YOKOGAWA CS3000 CentumVP
Suitable I/O card	ADV151
		ADV161
		ADV551
		ADV561
Supported controller YOKOGAWA STARDOM
Suitable I/O card	NFDV151
		NFDV161
		NFDV551
		NFDV561

Contact type	1 N/O contact
Type of switch contact	Double contact
Contact material	AgNi, 5 µm hard gold-plated
Maximum switching voltage	< 25 V AC
Maximum switching voltage		48 V DC
Limiting continuous current	1 A
Min. switching current	1 mA
Interrupting rating (ohmic load) max.	24 W (24 V DC)
		48 W (48 V DC)
		25 VA (25 V AC)
Mechanical service life	approx. 2x 10⁷ cycles

Field level
Connection method	Spring-cage connection
Conductor cross section rigid	0.2 m² ... 4 mm²
Conductor cross section flexible	0.2 mm² ... 2.5 mm²
Conductor cross section AWG	24 ... 12
Controller level
Connection method	Yokogawa KS-compatible
Number of connections	2
Number of positions	50
Note	Usable system cables: Phoenix Contact YUC50, Yokogawa AKB331
Tightening torque	0.5 Nm

Status display	LED red
Status display present	Yes, if the fuse fails
Operating voltage display	Green LED

Dimensional drawing
Width	343.5 mm
Height	125.5 mm
Depth	70.5 mm

Ambient conditions
Degree of protection	IP00
Ambient temperature (operation)	-20 °C ... 50 °C
Ambient temperature (storage/transport)	-20 °C ... 70 °C
Altitude	≤ 2000 m