FL SWITCH 2412-2TC-2SFX - Industrial Ethernet Switch Phoenix Contact

Mã sản phẩm: 1088875

Danh mục: PHOENIX CONTACT, Tự động hóa Phoenix Contact,

Managed Switch 2000, 12 RJ45 ports 10/100 Mbps, 2 SFP ports 100 Mbps, 2 Combo ports 10/100 Mbps, PROFINET Conformance-Class B, Extended temperature range

Liên hệ mua hàng

Hãng sản xuất: PHOENIX CONTACT

Chất lượng: Mới 100%

Bảo hành: Chính hãng

Chứng từ: CO/CQ, hóa đơn VAT

Liên hệ(SĐT/Zalo): 0933612627

Mô tả

Dimensional drawing
Width	214 mm
Height	113 mm
Depth	67 mm

General

Support by phone or on-site (fee is charged)

Material base plate	Die-cast aluminum, corrosion-resistant
Housing material	Stainless steel 1.4301

Mounting type

DIN rail mounting

Ethernet (RJ45)
Connection method	RJ45
Note on the connection method	Auto negotiation and autocrossing
Transmission speed	10/100 Mbps
Transmission physics	Copper
Transmission length	100 m (per segment)
Signal LEDs	Data receive, link status
No. of channels	12 (RJ45 ports)
Ethernet (SFP)
Number of interfaces	2
Connection method	SFP
Transmission speed	100 Mbps (full duplex)
Transmission physics	Depending on the SFP module
Transmission length	up to 40 km (depending on the SFP module used)
Signal LEDs	Data receive, link status
No. of channels	2 (SFP ports)
Ethernet (combo)
Number of interfaces	2
Connection method	SFP/RJ45
Note on the connection method	Auto negotiation and autocrossing
Transmission speed	10/100 Mbps (full duplex)
Transmission physics	Depending on the SFP module
Transmission length	up to 40 km (Depending on the fiber/SFP module used)
Signal LEDs	Data receive, link status
No. of channels	2 (Combo ports)

Type	Block design
Product type	Switch
Product family	Managed Switch 2000
MTTF	238.46 Years (SN 29500 standard, temperature 25°C, operating cycle 21%)
		137.07 Years (SN 29500 standard, temperature 40°C, operating cycle 34.25%)
		21.04 Years (SN 29500 standard, temperature 70°C, operating cycle 100%)
Special properties	Extended temperature range
Signal delay	≥ 6.5 µs (Store and Forward mode, 10/100 Mbps, depending on the frame size)
Insulation characteristics
Protection class	III (VDE 0106)
Degree of pollution	2
Switch functions
Diagnostic functions	RMON History
		LLDP (Link Layer Discovery Protocol)
		SNMP-Traps
		N:1-Portmirroring
		ACD (Address Conflict Detection)
		SysLog
		CRC-Surveillance
Basic functions	Store-and-forward switch, complies with IEEE 802.3
Signal contact control voltage	typ. 24 V DC
PROFINET conformance class	Conformance-Class B
PROFINET device function	PROFINET device
PROFINET device function		Fast Startup
Filter functions	Quality of Service (8 priority classes)
		Class of Service
		DiffServ/DSCP
		Port-Priorisierung
		VLAN (up to 32 VLANs)
		IGMP Snooping/Querier (v1/v2)
		Auto-Query-Port
		Extended Multicast Filtering
IP parameterization	DHCP-Client
		DHCP Option 82 (Relay Agent)
		DHCP server (pool-based, port-based)
		BootP
		DCP (Discovery and Configuration Protocol)
MAC address table	8k
Management	Web-based management (HTTP/HTTPS)
		Role-based user management (LDAP, RADIUS)
		SNMPv1/v2/v3
		Command-line interface (Telnet, SSH)
Redundancy	MRP (Media Redundancy Protocol)
		RSTP (Rapid Spanning Tree Protocol)
		FRD (Fast Ring Detection)
		Large Tree Support
		LACP (Link Aggregation Control Protocol)
		PROFINET S2 system redundancy
Status and diagnostic indicators	LEDs: US1, US2 (power supply), Fail (alarm contact), 2 LEDs per Ethernet port (Link/Activity and Speed)
Additional functions	Transmission of MMS and GOOSE (IEC 61850-8-1)
Additional functions		Transmission of Modbus/TCP
Time synchronization	SNTP (Simple Network Time Protocol)
Security functions
Port security	MAC-based, RADIUS (IEEE 802.1X), MAC Authentication Bypass
Basic functions	Store-and-forward switch, complies with IEEE 802.3

Local diagnostics	US1/2 Supply voltage US1, US2 Green LED
		FAIL Div. LED red
		LNK/ACT Link status Green/orange LED
		SPD Data transmission speed Green LED
Maximum power dissipation for nominal condition	9.31 W (U_S = max, T_amb = max)
Test voltage	500 V DC
Test section	for one minute 500 V DC
Transmission medium	Copper
Transmission medium		FO
Supply
Supply voltage (DC)	24 V DC (redundant)
Supply voltage range	19.2 V DC ... 32 V DC
Power supply connection	Via COMBICON, max. conductor cross section 2.5 mm²
Residual ripple	3.6 V_PP (within the permitted voltage range)
Max. current consumption	490 mA (U_S = min, T_amb = max)
Typical current consumption	320 mA (at U_S = 24 V DC and 25 °C ambient temperature)
Function
Signal contact control voltage	typ. 24 V DC

Connection method	Push-in spring connection
Note on the connection method	Use only copper connecting cables providing the permitted temperature range (-40 °C ... 75 °C).
Conductor cross section, rigid	0.2 mm² ... 1.5 mm²
Conductor cross section, flexible	0.2 mm² ... 2.5 mm²
Conductor cross section AWG	24 ... 16
Stripping length	10 mm

Ambient conditions
Degree of protection	IP20
Ambient temperature (operation)	-40 °C ... 70 °C
Ambient temperature (storage/transport)	-40 °C ... 85 °C
Permissible humidity (operation)	10 % ... 95 % (non-condensing)
Permissible humidity (storage/transport)	10 % ... 95 % (non-condensing)
Shock (operation)	30g (EN 60068-2-27)
Vibration (operation)	in acc. with IEC 60068-2-6: 5g, 150 Hz
Air pressure (operation)	79 kPa ... 108 kPa up to 2000 m above mean sea level (Without derating)
Air pressure (storage/transport)	79 kPa ... 108 kPa up to 2000 m above mean sea level (Without derating)

Free from substances that could impair the application of coating

Yes

UL, USA/Canada
Identification	cULus
Corrosive gas test
Identification	ISA S71.04.2013 G3 Harsh Group A
DNV GL data
Temperature	B
Humidity	B
Vibration	A
EMC	B
Enclosure	Required protection according to the Rules shall be provided upon installation on board

Conformance with EMC directives	EN 61000-6-2 EN 61000-4-2 (ESD) Criterion B
		EN 61000-6-2 EN 61000-4-3 (electromagnetic fields) Criterion A
		EN 61000-6-2 EN 61000-4-4 (EFT burst) Criterion A
		EN 61000-6-2 EN 61000-4-5 (surge) Criterion A
		EN 61000-6-2 EN 61000-4-6 (line noise immunity) Criterion A
		EN 61000-6-2 EN 61000-6-4 (interference) Class A
		EN 61000-6-2 EN 61000-6-4 (conducted interference) Class A
Noise immunity	EN 61000-6-2
Electromagnetic compatibility	Conformance with EMC Directive 2014/30/EU
Noise emission	EN 61000-6-4